Valve Stem
Faceplate
Screw
Insert
Handle
4. Install the Faceplate and Handle
CAUTION: Risk of product damage to the K-306–KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove and discard the plaster guard and/or dome, if installed.
Install the faceplate onto the valve. Secure with two screws. Do
not overtighten.
Rotate the valve stem fully counterclockwise.
Slide the sleeve over the valve stem.
Lever Handle
Properly align the handle downward.
Press the handle and insert firmly onto the valve stem.
Secure the handle in place with the washer and screw.
Press the plug button firmly into place in the handle.
Acrylic Handle
Attach the insert and align it so the dot on the front edge is
facing downward in the 6 o'clock position.
Slide the O-ring into position and attach the handle. Make sure
the handle is aligned identically to the insert.
Secure the handle in place with the washer and screw.
Push the plug button firmly into place in the handle.
1006260-2-C
Discard plaster guard
with dome.
Screw
Sleeve
O-Ring
Washer
Screw
8
Insert
Handle
Washer
Screw
Plug Button
Kohler Co.