Kalorik USK VC 16107 Manual De Instrucciones página 10

Fax +32 2 359 95 50
Cleaning the HEPA filter
• After emptying the dust container clean the
HEPA filter if necessary.
• To do so, you can detach the HEPA filter by
turning it anti-clockwise.
• It is also possible to take out the HEPA filter by
removing the top cover of the dust container.
To do so, hold the dust container with one hand
and turn the turning button on top of the
container with anti-clockwise with the other
hand to take out the cover and filter assembly.
To detach the HEPA filter from the cover, turn it
anti-clockwise.
• There is a nylon filter around the HEPA filter. You can easily
remove it.
• Clean both filters under clear running water (never use
detergents or other cleaning agents) and allow them to dry.
• Put the nylon cover around the HEPA filter, and attach this
assembly back on the top cover of the dust container.
• If you loosened it before, as explained above,
attach the top cover back on the dust container
by aligning the arrow on the cover with the open
padlock on the dust container and rotating it until
the arrow aligns itself with the closed padlock.
Check that it is closed properly.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/28
USK VC 16107 - 080409