Singer HD0400S Manual De Instrucciones página 6

IMPORTANT SAFETY INSTRUCTIONS
When using this machine, basic safety precautions should always be followed including the following.
Read all instructions before using the machine.
DANGER
· The machine should never be left unattended when plugged in. Always unplug
the machine from the electric outlet immediately after using and before
cleaning.
WARNING
· Be sure that the electrical voltage of the electric outlet (wall receptacle) is the
same as the rated voltage of the motor.
· Use this machine only for its intended use as described in this Instruction
Manual. Use only attachments recommended by the manufacturer as contained
in the Instruction Manual.
· To disconnect, turn all controls to the off ("0") position, then remove plug from
outlet.
· Disconnect the power line plug from the socket outlet or switch the machine off
when making any adjustments in the needle area, such as threading needle
and loopers, changing needle, changing throat plate or changing presser foot, etc.
· Always unplug the machine from the electrical outlet when removing covers,
lubricating, or when making any other user servicing adjustments mentioned
in the Instruction Manual.
· Do not attempt to adjust the motor belt. Contact your nearest Service Center
should any adjustment be required.
· Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
· Handle the foot controller with care and avoid dropping it on the floor. Be sure
not to place anything on top of it.
· Always use the proper throat plate. The wrong plate can cause the needle to
break.
· Do not use bent needles.
· When sewing, keep fingers away from all moving parts. Special care is required
around the sewing machine needle.
· Do not pull or push fabric while stitching. It may deflect the needle causing it to
break.
· Use only the handle to lift and move the machine.
· Never operate the machine if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into the water. Return
the machine to the nearest authorized dealer or Service Center for examination,
repair, electrical, or mechanical adjustment.
· Never operate the machine with any air openings blocked. Keep ventilation
openings of the machine and foot controller free from the accumulation of lint,
dust and loose cloth.
· Never drop or insert any object into any opening.
2
- To reduce the risk of electric shock:
- To reduce the risk of burns, fire, electric shock or injury to
persons: