Default Settings; Cabling - Atlantis Land NetServer Pro Guia De Inicio Rapido

4 RESET

1.4 Default Settings

Before you configure the NetServer Pro, you need to know the following
default settings:
Password:
Username:
IP address : 192.168.0.1

1.5 Cabling

Follow these steps for a trouble-free start of the print server operations
with your print server.
1. Confirm proper operation of the printer to be connected to the print
server.
2. When you have confirmed proper operation of the printer, turn off its
power.
3. Confirm that your network is operating normally.
4. Connect the print server to the network (through the RJ-45 connector
of the print server or IEEE 802.11g wireless interface).
5. While the printer is powered off, plug the print server to the printer
(USB interface).
6. Turn on the printer's power.
Press this button for 10 seconds to
restore factory default setting.
Configuration problems may result if the print server is
powered up without first establishing its network
connection. Please follow this procedure to avoid
complications at the configuration stage.
ENGLISH
24