Cequent Performance Products 76104 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Vehicle
Cross Member
③
Figure 1
Standard installation
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch installation.
Standard installation:
Lower muffler – If required.
1.
Raise hitch into position – raise hitch onto the vehicle cross member and align holes in hitch with existing holes in cross member.
2.
Install fasteners - Install (4) ½-13 x 4.50 long bolts, conical toothed washers, and Hex Flange Lock Nuts as shown in figure 1.
3.
4. Tighten all ½-13 GR5 fasteners with torque wrench to 75Lb.-Ft. (102N*M)
Raise muffler – If lowered in step 1.
5.
Mopar off road bumper installation:
Lower muffler – If required.
1.
Remove factory bolts and spacer plate – remove (4) M12 flange head bolts from forward side of vehicle cross member. Remove the spacer plate located between
2.
the vehicle cross member and the Mopar bumper. Return spacer plate to vehicle owner.
Raise hitch into position – raise hitch onto the vehicle cross member and align holes in hitch with existing holes in cross member.
3.
Install fasteners – reinstall (4) factory M12 flange head bolts through hitch and cross member and into existing weldnuts in Mopar bumper.
4.
5. Tighten all M12 CL10.9 fasteners with torque wrench to 75Lb.-Ft. (102N*M)
Raise muffler – If lowered in step 1.
6.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 76104, 84104, CQT76104
①
②
Rear
MOPAR Bumper
Existing Weldnuts
(4) Places
Conical Washer
Teeth side
Against hitch
Printed in Mexico
Reuse Factory
M12 CL10.9
Vehicle
Flange head bolts
Cross Member
(4) Places
Vehicles with MOPAR Off Road Bumper #82213654
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 3 of 18
Fastener Kit: 76104F
① Qty.(4) Bolt
½-13 x 4.50 Lg. Gr5
② Qty. (4) Conical Toothed
Washer 1/2"
3 Qty. (4) Hex Flange Lock Nut
½-13 Grade G
Spacer Plate
Figure 2
76104NP 8-25-16 Rev. A