Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: for models without Fascia popout.
1.
Locate the central rib inside the bumper fascia.
From the top of the rib, measure down 6 1/4", then scribe a line 3 3/4"; approximately 1 7/8" to the left and right. The scribed line should be centered with the
2.
rib, as shown.
Using the newly scribed line as the bottom portion of a rectangle, scribe the remaining sides of a rectangle; 6 1/4" tall by 3 3/4" wide.
3.
4.
Cut out scribed section.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Cequent Performance Products – Printed in Mexico
© 2014, 2016
Fascia Trimming Instructions
Audi Q5
Top to bottom of section should be no greater than 6
¼". Width section should be no greater than 3 ¾".
Cut out scribed Section.
Sheet 3 of 9
N75940
01-26-16
Rev. C
Form: F205 Rev A 5-6-05
Publicidad
