Cequent Performance Products 24939 Instrucciones De Instalación página 5

5. Drill holes – being careful lower hitch making sure not to knock forward
bolts into frame rail. Re-attach pull wires and remove or push current
fastener out of way. Drill holes and remove any burrs.
7. Re-install heat shield – Re-install heat shield – Re-install trimmed heat
shield. Sandwiching the remaining tab of heat shield between frame rail
and hitch.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Install fasteners – Install the rear fasteners into drilled holes. Feed the coiled
end of the pull wire through the drilled hole in the frame rail and out the access
hole. Pull the pull wire with fasteners into location through the hole. Leave pull
wires attached. Repeat the same process on both frame rails. Re-install or pull
forward fastener into place. Leave pull wires attached.
8. Install hitch – Raise hitch into position, feed pull wire through
corresponding holes on hitch. Using the conical washer to hold the bolt in
place remove the pull wires and attach the hex nut. Tighten to hold hitch
in place, repeat on all fasteners.
Sheet 5 of 18 24939N 3-4-16 Rev. A