Descargar Imprimir esta página

Danze D302555SNPVT Manual De Instrucciones

Publicidad

Enlaces rápidos

Roman Tub Trim Assembly
Ensamblaje de componentes exteriores
para grifo de banera romana
Ensemble de garniture pour bain romain
Hex wrench
Llave hexagonal
Clé hexagonale

Publicidad

loading

Resumen de contenidos para Danze D302555SNPVT

  • Página 1 Roman Tub Trim Assembly Ensamblaje de componentes exteriores para grifo de banera romana Ensemble de garniture pour bain romain Hex wrench Llave hexagonal Clé hexagonale...
  • Página 2 Danze always recommends that plumbing products be installed by a licensed professional. Danze aconseja siempre que sea un profesional autorizado quien instale los productos de plomería. Danze recommande que les articles de plomberie soient toujours installés par un professionnel qualifié.
  • Página 3 3> Using Allen Wrench supplied, back out setscrew a few truns. 4> Place spout over spout hub and insert pin into the small hole in the spout escutcheon and then tighten setscrew. Finish installation by inserting set Use la llave hexagonal que se incluye y déle unas vueltas screw hole cover into access hole in back of spout.
  • Página 4 3. For Installations with Soft Touch Personal Spray/Instalaciones con rociador Soft Touch/ Installations avec la douchette personnelle Soft Touch If your trim included Soft Touch Personal Spray, please refer to step 6-8 for spray installation. If not, please go to step 9. Si los components incluyen rociador Soft Touch, siga los pasos 6 a 8 para su instalación.
  • Página 5 Diverter replacement/service Reemplazo del cambiador de flujo de agua Remplacement/réparation de l’inverseur Shut off main water supply before replacement. Cierre la llave de paso antes de hacer el cambio. Couper l’alimentation d’eau principale avant d’effectuer le remplacement. 1> Remove spout insert (located at base of spout opposite outlet side). Loosen 2>...
  • Página 6 5> Place the spout and spout base onto the spout hub. Please note, that the spout pin must be aligned with hole of spout base ring. Finish installation by tightening setscrew and installing spout insert. Vuelva a colocar el vertedor y su base en el ensamblaje interno del vertedor.