Removing The Collected Water - Comfee MDDP-50DEN7 Manual De Instalación

Removing the collected water

There are three ways to remove collected water.
1. Use the bucket
● When the bucket is full, the Full indicator light will illuminate,
the digital display shows P2.
● Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does not
spill. Do not put the bucket on the floor because the bottom
of the bucket is uneven. Otherwise the bucket will fall and
cause the water to spill.
● Throw away the water and replace the bucket. The bucket
must be in place and securely seated for the dehumidifier to
operate.
● The machine will restore to its original state when the bucket
is replaced in its correct position.
NOTES:
● When you remove the bucket, do not touch any parts inside
of the unit. Doing so may damage the product.
● Be sure to push the bucket gently all the way into the unit.
Banging the bucket against anything or failing to push it in
securely may cause the unit not to operate.
● If the pump hose drops when you remove the bucket (see
Fig.7), you must reinstall the pump hose properly to the unit
before replace the bucket into the unit (see Fig.8).
● When you remove the bucket, if there is some water in the
unit you must dry it.
● When the unit is on, if the bucket is removed, the compressor
and the fan turn off, then the unit will beep 8 times and the
digital display shows Eb.
● When the unit is off, if the bucket is removed, the unit will
beep 8 times and the digital display shows Eb.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even strength, and pull it
out from the unit.
3. Pour the water out.
Reinstall pump hose properly
17
OPERATING THE UNIT
Fig. 5
Fig 6
Pump hose drops
Fig 7
Fig 8