Electrical Information - Comfee MDDP-50DEN7 Manual De Instalación

SAFETY PRECAUTIONS
avoid a hazard.
● The appliance shall be installed in accordance with national wiring regulations.
● The appliance with electric heater shall have at least 1 meter space to the combustible materials.
● Contact the authorised service technician for repair or maintenance of this unit.
● Do not use the socket if it is loose or damaged.
● Do not operate your air conditioner in a wet room such as a bathroom or laundry room.
● Do not use this product for functions other than those described in this instruction manual
● Contact the authorised installer for installation of this unit.
● If the air conditioner is knocked over during use, turn off the unit and unplug it from the main power supply immediately. Visually
inspect the unit to ensure there is no damage. If you suspect the unit has been damaged, contact a technician or customer service
for assistance.
● In a thunderstorm, the power must be cut off to avoid damage to the machine due to lightning.
● To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
● Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture
or appliances. Arrange cord away from traffic area and where it will not be tripped over.
● Do not open the unit during operation.
● When the air filter is to be removed, do not touch the metal parts of the unit.
● Hold the plug by the head of the power plug when taking it out.

Electrical Information

● The manufactures nameplate is located on the rear panel of the unit and contains electrical and other technical data specific to
this unit.
● Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is important. The power cord is
equipped with a three-prong grounding plug for protection against shock hazards.
● Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is not adequately grounded
or protected by a time delay fuse or circuit breaker(the fuse or circuit breaker needed is determined by the maximum current of the
unit. The maximum current is indicated on the nameplate located on unit), have a qualified electrician install the proper receptacle.
● Ensure the receptacle is accessible after the unit installation.
● Do not use extension cords or an adapter plugs with this unit. However, if it is necessary to use an extension cord, use an
approved "Dehumidifier" extension cord only (available at most local hardware stores).
● To avoid the possibility of personal injury, always disconnect the power supply to the unit, before installing and/or servicing.
● All wiring must be performed strictly in accordance with the wiring diagram located on the middle baffle of the unit (behind of the
water bucket).
Take note the fuse specifications
The unit's circuit board(PCB) is designed with a fuse to provide overcurrent protection. The specifications of the fuse are printed
4