Plantronics DUOSET II Manual Del Usuario página 8

4757 Duoset II Rev C
PREPARING THE HEADSET FOR OVER-THE-EAR USE:
Fig.1 Unsnap the headband from the back of the receiver.
Fig.2 Remove both the foam ear cushion and the moulded cushion
holder from the receiver. They can be removed as one item.
Fig.3 Press the pivot ball ring onto the headset, aligning it with the
microphone boom. Insert the earhook into either the left or right
hand side of the pivot ball ring, depending which ear the headset
is to be worn on.
Fig.4 Place the headset over your ear as shown in the diagram and
a&b gently press the receiver against your ear for a comfortable fit.
Adjust the conformable earhook around your ear in order to
obtain a comfortable fit.
The headset cable can be slotted over the top of the earhook,
for greater ease of use and comfort.
Fig.7 Clothing Clip
The clothing clip helps to keep the headset free from the weight
of the headset cable. Attach the clip to your clothing at a
comfortable level.
Fig.8 Quick Disconnect
Some headset models are equipped with a Quick Disconnect
Connector. When you separate the Quick Disconnect, you place
an on-going conversation 'on hold' without removing the headset.
Before using your headset, join the Quick Disconnect to the
mating connector of your adapter cable. To put your call 'on hold',
grasp the Quick Disconnect as shown, and pull straight apart. To
resume your conversation, reconnect the two halves.
Fig.9 Hook Switch Control
For certain DECT applications, the headset is available with an in-
line hook switch control. You can use this switch to answer
or end a call.
3
8/9/00 3:21pm Page 8
DIAGRAM KEY
TM Connector
GB
6 3