Event Search - Avtech IC-AVH516 Manual De Instrucciones

How to set a preset point:
Step1:
How to go to a preset point:
Step1:

4.5 Event Search

Note: This function is not available for "NORMAL" and "GUEST". For details, please refer to "4.3 User
Level Creation" at page 13.
In the playback control bar, click
QUICK SEARCH
RECORD
MOTION
ALARM
TIME
HUMAN DETECTION*
SYSTEM
FULL
STATISTIC
EXIT
*For selected model only
 To quickly search the time within which might include the recorded data you want to see:
- Select the channel(s) and month you want to search. You'll see the date(s) with recorded data is highlighted.
- Select the date you want to search. You'll see the time with recorded data is highlighted from the timeline bar.
- Click the time to start playback.
 To search the recorded data by event, select RECORD / MOTION / ALARM / TIME, or select FULL to show all the
event logs. Select the log you want to start playback.
Note: During video playback, you might click
the recorded audio (if any) on the channel you want.
Step2: Select the numbering within which saves the camera view you want to see,
and wait till you see
on the device status bar.
to enter the search list.
EVENT INFORMATION
HARD DISK
CHANNEL
2009
SUN MON
1 2
8 9
15 16
22 23
29 30
00 06
Step2: Click or
/ /
configure as a preset point.
Step3: Click the numbering you want to configure for this point,
and wait till you see
and disappearing on the device status bar.
Step4: Repeat from Step1 again to set other points if needed, or
click to return to the preset point selection panel
(command sending) appearing and disappearing
TUE WED THU
3 4 5
10 11 12
17 18 19
24 25 26
12
15 : 20
to check the recorded data details, or click
16
FREQUENTLY-USED FUNCTIONS
to the proper ratio you need, and click
/ to move to the point you want to
(command sending) appearing
ALL HDD

2 SELECTED

NOV
FRI SAT
6 7
13 14
20 21
27 28
18 24
SUBMIT
to play