Notify; Push Video - Avtech IC-AVH516 Manual De Instrucciones

5.4.8 NOTIFY

You can configure this recorder to send notifications for certain events to mobile devices with our mobile app,
EagleEyes, installed, or to the specified E-mail address(es).

PUSH VIDEO

(for selected models only)
Before using this function, make sure:
 The camera connected to this recorder is our ETS network camera series.
® ®
 You have iPhone , iPad
 You have subscribed the mobile network service from your mobile service provider.
 The mobile app, EagleEyes, is installed in your mobile device. For details, please refer to "APPENDIX 4 MOBILE SURVEILLANCE
VIA EAGLEEYES" at page 45.
 You have configured EagleEyes to access this recorder, and Push Video is enabled. For details, please refer to "APPENDIX 5 SET
PUSH VIDEO" at page 46.
You'll get an active event notification with video telling you the occurrence of alarm event(s).
CONNECTION PUSH VIDEO
CAMERA RESET ALL GUARD CONNECTION
DETECTION GUARD
ALERT CH01
NETWORK CH02
DISPLAY CH03
RECORD CH04
NOTIFY
PSE
MULTICASTING
EXIT
Step1: Switch "GUARD" to "ON".
Step2: Select the channel number with our ETS network camera connected, and select the alarm type to
"ALARM N.C.", "ALARM N.O.", or "INTERNAL ALARM" (shown only when the connected ETS camera
has an alarm sensor built-in).
Step3:Customize the notification message you want to see after alarm type setting, or keep the default message,
which shows only the channel numbering.
Step4: Enable "Push Video" in EagleEyes on your mobile device, and try to trigger an alarm event to see if you'll
get Push Video.
, or Android™ mobile phone or tablet.
ADVANCED CONFIG
PUSH STATUS MESSAGE MAIL
ALARM N.C.
ALARM N.O.
ALARM OFF
ALARM OFF
VIDEO MAIL
37
MAIN MENU
VIDEO FTP
SUBMIT
ON
CH1
CH2
CH3
CH4