Fan Assembly - Craftmade Merit Guia De Instalacion

7. Fan Assembly.

Without removing motor assembly from
j-hook, slide motor assembly over mounting
plate, aligning holes in top plate of motor
assembly with screws in mounting plate.
Re-insert the 4 flat washers and 4 lock nuts
previously removed (page 4, Section 4) to
secure motor assembly. Tighten all 4 lock
nuts. [Refer to diagram 1.]
Note: Make sure wires and wire connectors
do not get tangled or pinched between the
plates.
Raise motor housing to mounting plate,
aligning 4 metal bars on the inside edge of
motor housing with 4 posts on edge of
mounting plate . Twist motor housing to the
RIGHT to lock. [Refer to diagram 2.]
WARNING: It is important that you make
sure to turn the motor housing all the way to
the right to ensure that the motor housing is
completely secure.
Remove 5 screws/washers from underside of
motor assembly. Align holes in center band
with screw holes in motor assembly, allowing
the male plug from motor assembly to come
through hole in middle of center band.
Re-insert screws/washers just removed and
securely tighten all 5 screws/washers with a
Phillips screwdriver. [Refer to diagram 3.]
flat washers
lock nuts
diagram 1
post
metal
bars
(inside)
diagram 2
male plug
diagram 3
page 6
mounting plate
motor assembly
mounting plate
motor
housing
motor assembly
center band