Chicco Walky Talky Manual De Instrucciones página 12

er, make sure that the knob is properly locked in place as
shown in figure 15.
11. To close the baby walker, turn the knob located under
the top part counter-clockwise and push it upwards. Then
lower the top part until completely closed (fig. 16).
WARNING: Do not close the baby walker with the child inside.
BAR SUPPORT
To properly use the bar support, starting from the rest po-
sition (resting on the upper part of the structure), do the
following:
- Pull the bar support out of the baby walker in the direction
of the arrow at the end of the intersections until it stops;
grab the bar in the middle part (fig. 17);
- Then rotate the bar support upwards, until it clicks locked
(fig. 18).
To take down the bar support and to bring it back in its
original position, follow these steps:
- Pull the bar support out of the baby walker in the direction
of the arrow at the end of the intersections until it stops,
holding it in the middle part (fig. 19);
- Then turn the bar support downwards (fig. 20), bringing it
back to the rest position (fig. 21).
WARNING: Keep your child away from all moving parts
whilst you adjust the baby walker.
WARNING: Do not move or lift the baby walker grabbing it
at the bar support or at features on it.
WARNING: Do not lean on the bar support.
ELECTRONIC TOY PANEL
WARNING: Regularly inspect the toy for signs of wear and
any damage. In case any part would be damaged or not
operating correctly, do not use the product and keep it out
of reach of children. Do not use it and/or try to repair it, but
contact qualified personnel only.
CARE AND MAINTENANCE OF THE ELECTRONIC TOY
PANEL
• WARNING: Clean the toy using a soft dry cloth to avoid
damaging the electrical circuit.
• WARNING: Protect the toy from heat, dust, sand and water.
• WARNING: The baby walker is not designed to be used
when feeding a child; do not use when feeding to avoid
damages or malfunctions of electrical parts due to con-
tact with food.
REMOVAL AND/OR REPLACEMENT OF BATTERIES
FROM ELECTRONIC TOY PANEL
WARNING:
• This toy requires 2 1.5V AA alkaline batteries (not included).
• Batteries must only be fitted by an adult.
• To fit and/or replace the batteries: Loosen the screw on
the battery compartment cover with a screwdriver and
open the cover, remove the spent batteries, fit the new
ones, making sure that they have been fitted with the cor-
rect polarity as shown in the battery compartment, fit the
cover again and tighten the screw.
• Always keep batteries and tools out of the reach of chil-
dren.
• Do not leave the product outside under the rain; water
infiltrations will damage the electronic circuit.
• Always remove discharged batteries from the product to
avoid any possible liquid leaks that may damage it.
• Always remove the batteries if the product will not be
used for a long period of time.
• Only use alkaline batteries of the same type or equivalent to
the type recommended for a correct product functioning.
• Never mix new and old or different types of batteries.
• Do not throw dead batteries in fire or leave them in the
environment; they must be disposed of through waste
sorting.
• Do not short-circuit the power terminals.
• Do not try to recharge non-rechargeable batteries: they
may explode.
• The use of rechargeable batteries is not recommended as
they may reduce the toy's operability.
• If the batteries are leaking liquid, replace them immedi-
ately, making sure to clean the battery compartment;
thoroughly wash your hands in the case of contact with
the liquid.
• If rechargeable batteries are used, remove them from
the toy before recharging and recharge them only under
adult supervision.
• Rechargeable batteries must be charged only under adult
supervision.
• Rechargeable batteries must be removed from the prod-
uct during recharging.
• Never use new and old batteries together as this will allow
the product not to function properly.
• Remove batteries from the product before dispose it.
THIS PRODUCT COMPLIES WITH THE DI-
RECTIVE 2012/19/EU.
The crossed bin symbol on the appliance in-
dicates that the product, at the end of its life,
must be disposed of separately from domes-
tic waste, either by taking it to a separate waste disposal
site for electric and electronic appliances or by returning
it to your dealer when you buy another similar appliance.
The user is responsible for taking the appliance to a spe-
cial waste disposal site at the end of its life. If the disused
appliance is collected correctly as separate waste, it can be
recycled, treated and disposed of ecologically; this avoids a
negative impact on both the environment and health, and
contributes towards the recycling of the product's mate-
rials. For further information regarding the waste disposal
services available, contact your local waste disposal agency
or the shop where you bought the appliance.
Made in China
0068
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use. The warranty shall not therefore apply in the case
of damages caused by improper use, wear or accidental
events. For the duration of warranty on conformity defects
please refer to the specific provisions of national laws appli-
cable in the country of purchase, where provided.
12
F
IM
C
N
RI
VE
FU
FA
SO
A
PL
LE
M
BA
H
A
•
• A
d
s
a
s
• A
s
• A
q
t
c
d
• A
c
f
t