Programming A Master Power Macro; Programming The Power Key For The Master Power Macro; Operating The Master Power Macro - One for All URC-4220 Manual Del Usuario

5.
6.

PROGRAMMING A MASTER POWER MACRO

In its default state, the
Remote Control will individually power your home entertainment devices
on or off. However, you can also program a
key that will sequentially turn on or off all the devices with a single
POWER
key press.

Programming The Power Key For The Master Power Macro

1.
2.
3.
4.
5.

Operating The Master Power Macro

1.
2.
Repeat step 4 (on the previous page) three more times for
remaining digits. Use
digit, and for the fourth digit.Write down the code dig-
4
its in the remaining TV code boxes on page 8.
To check for codes of other devices, repeat steps 1
through 5 (starting on the previous page), but substitute
the appropriate device key for each device you are check-
ing. Write down the device's code digits in the appropri-
ate code boxes on page 8.
key on the One For All 4 Device Universal
POWER
Press and hold
then release
SET
Enter - - . The
9 9 5
once.
For the first device you want in the power-on sequence,
press its device key (e.g.,
Repeat step 3 up to three more times to add desired
devices to the power-on sequence (e.g.,
).
TV
To save the settings and exit the program, press and hold
until the
SET LED
After programming, point the remote control at the
devices and press
tially turn on (or off) your devices.
NOTE: When POWER is pressed for less than 2 seconds, a power com-
mand will only be sent to the currently-selected device. This allows
you to still individually power devices on or off.
Devices will turn on (or off) according to your
programmed sequence.
NOTE: The currently-selected device will always turn on or off first,
followed by the remaining programmed sequence. After the master
power sequence has been completed, the remote control will be set to
control the first powered-on device.
NOTE: If one or more devices does not have a POWER key, the power
off/on sequence may be slightly delayed when the remote control signals
the device(s). This action is normal.
for the second digit,
2
Master Power Macro
until the
SET LED
.
will blink twice. Then press
LED
CBL/SAT
blinks twice, then release
for at least 2 seconds to sequen-
POWER
10
for the third
3
onto the
(red light) blinks twice,
) once.
VCR/PVR
.
SET
continued on next page...
POWER
, , and
DVD