1-4.WIring For The Receiver; Wiring Diagram; 1-5.INstalling The Receiver - Panasonic CZ-RWSU2N Manual Del Usuario

Wiring Diagram

Indoor unit
Terminals for RC
wiring
How to Connect the Wires
・ Connect the wires from the receiver to the terminals for RC wiring on the indoor unit.
(No polarity)
 The receiver can only be installed on the corner indicated in Fig. A. Consider how the panel will
face when it is installed on the indoor unit.
1 Remove the air inlet grill.
2 Remove the screw holding the adjustable corner cover. Then slide the cover to the side and remove it. (Fig. B)
Receiver position
Fig. A
Box with
indoor unit's
electrical
parts
3 To pass the wire through the panel, bend the part (shaded area) on the square hole and then
pass wire protruding from the wireless receiver through the grill. (Fig. C)
4 After wiring according to the directions in "Wiring for the Receiver" below, leave enough wire length so
that the receiver's adjustable corner cover can be removed and fasten the wire with the clamper. (Fig. C)
5 Hang the corner cover string on the pin of the ceiling panel (Fig. D). Then slide the corner cover
onto the ceiling panel until the three clips are correctly located and fix it in place with the screws.
 Make sure the wire is not caught.
 Refer to the installation instructions supplied with the panel.
Fig. C
Bend the part (shaded
area) with a screwdriver
or similar implement to
allow the wire to pass
through.
 For more information about wiring and test operation, see the sections on "Wiring for the Receiver" and
"Test Operation" .
1-4. Wiring for the Receiver
Receiver PCB
CN001
1
2
1-5. Installing the Receiver
Adjustable corner cover
Fig. B
Screw
Fix it in place
with the
clamper.
2P white
Fig. D
Fix the
screw.
Make sure the three clips on the corner
cover are located over the holes on the
ceiling panel and fix it in place with the
supplied screws.
CZ-RWSU2N
Ceiling panel
Adjustable corner cover
Pin
5