Bissell POWERGLIDE 1305 Serie Guia Del Usuario página 9

Maintenance:
1
Unplug vacuum, turn over and
unscrew 7 Philips head screws
to remove bottom cover
Maintenance:
TurboEraser® Tool
1
Align
Slot
Twist gray collar
counter-clockwise, until
slot appears, and then
separate faceplate
Carefully remove brush,
replace belt and brush,
if needed
WARNING
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt
Container in place. Allow components to dry before reassembling the Dirt Container.
Replace the Brush & Belt
2
Pull roller straight
out, threading
through belt
Maintain the TurboBrush®/
2
Paddle Wheel
If paddle wheel gets dislodged,
align two clips on each side and
pop into place
3
End Cap
Replace roller and/or belt.
To reassemble roller, thread
through belt and line up End
Cap, then place bottom cover
back on and replace 7 screws.
3
Roller
Belt
Paddle Wheel End
Faceplate will not
close properly if all
parts are not aligned
correctly
*images may vary
www.BISSELL.com
Belt
Clip
9