Kohler K-8524 Manual Del Usuario página 4

K-8524: 28" (71.1 cm)
K-9069: 22-3/4" (57.8 cm)
Mark the bottom mounting
minimum 48" (121.9 cm).
1. Install the Posts
Locate the Mounting Holes
IMPORTANT! The slide bar must be mounted to stud framing
supports at both the top and bottom mounting locations. Do not use
or depend on plastic wall anchors to attach the slide bar.
NOTE: The slide bar should not be installed in an area 24" (61 cm)
to 48" (121.9 cm) from the floor.
For K-8524: Mark the top mounting hole location then measure
down 28" (71.1 cm) from the first mark to determine the bottom
mounting hole location. Verify both marked locations are over a
stud.
For K-9069: Mark the top mounting hole location then measure
down 22-3/4" (57.8 cm) from the first mark to determine the
bottom mounting hole location. Verify both marked locations are
over a stud.
For tile or solid surface material: Drill a 3/16" hole through the
finished surface only. Do not drill into the stud or the screws may
not hold.
Install the Escutcheons and Posts
Apply silicone sealant into the groove on the backside of an
escutcheon.
Position an escutcheon and post over the top mounting hole.
1046145-2-C
Escutcheon
Mounting
Hole
Screw
4
Post
Kohler Co.