Kohler K-8524 Manual Del Usuario página 6

Post
2. Install the Slide Bar
While holding the post, thread the pin into the post. Tighten with
a flat blade screwdriver. Repeat for the other pin.
Line up the hole in the lock assembly with the hole in the slide
bar. If needed, use a small screwdriver to adjust the position of
the slide bar locks at each end of the slide bar assembly.
Align the pins with the holes in the slide bar and slide bar locks.
Gently press the slide bar against the posts, inserting the pins into
the slide bar locks. The slide bar should fit snug against the posts.
Secure the slide bar by tightening the setscrews into the slide bar
locks until the setscrew is snug against the pins.
Press the caps into either end of the slide bar.
1046145-2-C
Pin
Lock Assembly
Setscrew
O-Ring
Cap
6
Handshower
Holder
Slide Bar
Kohler Co.