Tool it DBT400 Instrucciones De Operación página 3

battery. It can produce a short circuit current high enough
to weld a ring or the like to metal causing a severe burn.
INSERTION OR REPLACEMRNT OF LEAD WIRE：
1. Remove the cover in the backside bottom of the battery
tester.
2. Insert the connectors which contain black-yellow pair and
yellow-red pair in one end of the lead wire into the
sockets which can be found when you remove the cover
as above. Be sure to make colors matched between the
connectors and sockets as shown below.
Red (Connector)
Black
PREPARING TO TEST：
1. Be sure area around battery is well ventilated while
battery is being tested.
2. Clean battery terminals. Be careful to keep corrosion
from coming in contact with eyes.
3. Inspect the battery for cracked or broken case or cover. If
battery is damaged, do not use tester.
4. If the battery is not sealed maintenance free, add distilled
water in each cell until battery acid reaches level
specified by the manufacturer. This helps purge
excessive gas from cells. Do not overfill.
Yellow
Connect
white
EN - 3
Red Yellow (Socket)
White
Black
(RT003 Backside)