Environmental Protection - Krups BW 500 Manual Del Usuario

IFU precision meca nafta US_NC00013847-01.qxp:NC00013847-01
Repeat if necessary.
To descale your filter:
Soak the filter in white vinegar or diluted citric acid.
TROUBLESHOOTING
Never use a descaling method other than that recommended.
THERE IS NO EVIDENT DAMAGE TO YOUR KETTLE
• The kettle does not work or stops before coming to the boil:
- Make sure that your kettle is properly connected.
- If the kettle was switched on without water, causing the overheat cut-out to operate: let the kettle cool and fill it
with water and switch it on again: the kettle should start working again after approximately 15
- If an accumulation of scale has built up: de-scale the kettle. Refer to the De-scaling heading.
• The water tastes of plastic:
Generally, this happens when the kettle is new, don't drink the water from the first few boilings. If the problem
persists, fill the kettle to the maximum, add two teaspoons of bicarbonate of soda. Bring to the boil and don't drink
the water. Rinse out the kettle.
IF YOUR KETTLE HAS BEEN DROPPED, IF IT LEAKS OR IF THERE IS VISIBLE DAMAGE TO THE POWER CORD, THE
PLUG OR THE KETTLE BASE
Return your kettle to your KRUPS After Sales Service Center, for only they are authorised to carry out repairs.
Refer to the warranty conditions and the list of centres in the booklet supplied with your kettle. The type and serial
number are shown on the bottom of your kettle. This warranty covers manufacturing defects and domestic use only.
Any breakage or damage resulting from failure to follow these instructions for use is not covered by the warranty.
KRUPS reserves the right to modify the characteristics or components of its kettles at any time, in the interests of
the consumer.
No attempt must be made to dismantle the appliance or its safety devices.
If the power cord is damaged, it must be replaced by the manufacturer, their After Sales Service Center or a
similarly qualified person, to avoid any danger.
No attempt must be made to dismantle the appliance or its safety devices.
If the power cord is damaged, it must be replaced by the manufacturer, their After Sales Service Center or a similary
qualified person, to avoid any danger.

ENVIRONMENTAL PROTECTION

When disposing of the kettle, please consult your local collection office for proper disposal or return to an approved
Service Center for recycling.
10/12/09 15:10 Page 7
English
minutes.
7