Proper Air Circulation; Leveling Your Cooler; Install Limitations - Ashley Signature W100-11 Guia Del Usuario

After Unpacking Your Cooler
Find the best location to install your cooler near a 115 volt, 15 amp outlet.
Make sure there is proper air ventilation.

Proper Air Circulation

To assure your cooler works at the maximum efficiency it was designed
for and does not overheat, you should install it in a location where there is proper air
circulation and electrical connections.
The following are recommended clearances around the cooler:
Top................2"(50mm)
Sides..............2"(50mm)
Back...............4"(100mm)

Leveling Your Cooler

Your cooler has four (4) leveling legs which are located in the corners of
your cooler. After properly placing your cooler in its final position,
you can level your cooler.
Leveling legs can be adjusted by turning them clockwise to lower your
cooler or by turning them counterclockwise to raise your cooler.

Install Limitations

Do not install your cooler in any location not properly insulated or heated
e.g. garage etc.
Select a suitable location for the cooler on a hard even surface away
from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking
appliances etc. Any floor unevenness should be corrected with the leveling legs.
This cooler is designed to operate at approximately 37 degrees Fahrenheit, in a
room that has an ambient temperature of approximately 76 degrees Farenheit. The
temperature may fluctuate due to ambient temperate of the room where it is
located.
CR-48C
MODEL#:
Page 7 of 12