Door Alignment - Ashley Signature W100-11 Guia Del Usuario

DOOR ALIGNMENT (IF NEEDED)
1. Remove the top hinge cover using a flat head screw driver. Gently lift from the
rear of the hinge and slide forward.
2. Loosen the top hinge screws using a phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover by sliding the hinge cover from front and press
gently on the rear of the hinge cover to lock in place.
Reversing the Door Hinge
(Optional: To Change Direction Door Opens)
1. Remove the top hinge cover using a flat head screw driver. Gently lift from the
rear of the hinge and slide forward. (see Fig: 1)
2. Using a Phillips Head Screwdriver, loosen and remove the screws holding the
top hinge in place. (see Fig:2)
3. Remove the top hinge and carefully lift off the door.
4. Remove the screws hole plug and hole pad from the opposite side using a flat
head screw driver and insert the plug and pad in the screw hole openings of the
just removed screws.
5. Loosen the screws holding the lower hinge bracket and remove the hinge.
6. Remove the screws from the bottom of the front-left corner plate.
CR-48C
MODEL#:
Top Hinge Cover
Top Hinge
Screws Hole Plug
Hole Pad
Lower Hinge
Fig: 1
Fig: 2
Hinge on right side
Bottom View
Page 8 of 12