Clean The Filter; Battery Replacement - Roca SENTRONIC-S A5A8102C00 Manual De Instrucciones

6. Adjust the water flow rate
1. Use a hex wrench to disassemble the panel.(Please refer to "clean the filter" step 1.)
2. Apply with screw driver to adjust flow rate knob to its appropriate demand.(Please refer to "clean the filter" step 2 and 6.)

7. Clean the filter

The sensor valve is equipped with filter device, but if there is impurities in the pipe or the water quality is bad, the flushing result
will become bad after long term usage, then it is time to clean the filter.
1.
Use a hex wrench to
disassemble the panel.
5.
Re-installed filter.

Battery replacement

Disassembly the panel and the battery case, please use AA Alkaline batteries to replacing(DC type).
Attention:
• Please be aware of the positive and negative electrode direction of battery. The raised part of battery case should be
aligned with the slot of battery case.
• Without sealing the battery case firmly, this will affect the use, water-proof capability and life of product.
• The internal part of battery case required to be remained dry. Water penetration of battery case may influence the
battery life and product safety.
• New and old batteries should not be mixed for usage.
1
IR filter cleaning
Please keep IR filter clean, you may apply with neutral detergent and soft cloth for cleaning.
Cleanser, abrasive grinding powder, oil or acid or alkaline detergent are forbidden to apply to clean this product. Do not
directly spray air fresheners, disinfection liquid or other deodorizer, cleaning organic solvents to IR filter. Water resource
used for this product should be domestic water or applicant water in order to preventing to use acid, alkaline processed
water or dirty water containing more impurities.
2.
Stopping water supply.
6.
Turn on flow rate knob.
2
3.
Open filter cover and take out
filter net .
7.
Please be aware if the packing
is missed during filter cover
installation.
3
4
4.
Clean the filter.
8.
Use a hex wrench to assemble
the panel.
4