Table of Contents
Warnings ................................................................................................................................................................................1
Assembling the ExerSaucer ® ...................................................................................................................................................1
Adjusting the Height ...............................................................................................................................................................5
Attaching the Toys ...................................................................................................................................................................5
Care and Maintenance ...........................................................................................................................................................6
Limited Warranty .....................................................................................................................................................................7
Seat Pad
Tray
Pylon (3)
Registration Information
www.evenflo.com/registerproduct.
For future reference, record the Model Number and Date of Manufacture below.
Model Number:
Stabilizer Tube (3)
Seat Ring
8-16 X 18 mm Screw (12)
8-16 X 75 mm Screw (3)
(1) Hardware Kit Bag
1 Instructions
3 8-16 x 75 mm Screws
12 8-16 x 18 mm Screws
(1) Toy Kit Bag
6 Bags of Toys (including small tray)
Date of Manufacture:
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS! FAILURE TO DO SO COULD RESULT IN
NEVER leave child unattended. ALWAYS keep child in view while in the ExerSaucer ® .
Adult assembly required. Take care when unpacking and assembling; contains small parts and some items with sharp edges.
STRINGS CAN CAUSE STRANGULATION!
- DO NOT place the ExerSaucer
- DO NOT place items with a string around your child's neck such as hood strings or pacifier cords.
- DO NOT suspend strings over product or attach strings to toys.
NEVER use ExerSaucer near stairs or steps.
NEVER use ExerSaucer
NEVER use ExerSaucer in or near swimming pools or other bodies of water.
DO NOT fill the ExerSaucer tray with water.
DO NOT adjust height while baby is sitting in ExerSaucer.
DO NOT use the ExerSaucer
Foot (3)
NEVER use as a sled.
allow child to sleep in ExerSaucer.
spin baby in seat. Only permit baby to rotate the seat.
FALL HAZARD! Stop using ExerSaucer when your child reaches any of the following developmental stages:
- Can walk;
- Is over 30" (76 cm) tall;
- Can stand flat-footed in the ExerSaucer in the highest adjustment level;
- Can climb out of the product.
Allow only the baby's toes to touch the base. DO NOT allow the baby to stand flat-footed on the base.
use or store this product outdoors.
Wheel (4)
mix old and new batteries.
mix alkaline and standard (carbon-zinc) batteries. Use only batteries of the same or equivalent type.
DO NOT
DO NOT use rechargeable batteries.
DO NOT recharge non-rechargeable batteries.
Phillips Screwdriver
CAUTION: Tighten all screws until snug; do not overtighten. Use only screws provided.
DO NOT USE POWER TOOLS.
A
B
WARNING
SERIOUS INJURY OR DEATH!
ExerSaucer.
AND can hold up their head and neck unassisted.
1. Locate two stabilizer tubes
Turn the pylon
B
stabilizer tube
Make sure both stabilizer tubes are fully inserted into the
bottom of the pylon.
A
A
A
1
Tools Required
Assembling the ExerSaucer
A
and one pylon
B
.
B
upside down and insert one end of each
A
into the bottom of the pylon
B
, as shown.