Assembling The Exersaucer; Important - Evenflo ExerSaucer Jump & Learn MY FIRST PET Manual Del Usuario

Assembling the ExerSaucer

D
C
E
B
A B
A
A
B
2. Insert a foot C into the bottom of the pylon
D
Secure with one 8-16 X 75 mm screw
8-16 X 18 mm screws E . Tighten all five screws securely but
E
do not overtighten. DO NOT USE POWER TOOLS.
IMPORTANT: The foot MUST sit completely flat in the bottom
stabilizer tubes is not installed correctly or is not fully inserted.
the foot fits over it correctly.
3. Locate the other two pylons B . One at a time, turn them
upside down and completely insert the end of a stabilizer
tube A in each pylon, as shown.
Make sure the stabilizer tubes are fully inserted into the
bottom of each pylon.
A
4. Locate the third stabilizer tube and insert into both
pylons B , as shown.
Make sure the stabilizer tube is fully inserted into the
bottom of each pylon.
B
2
B , as shown.
C
and four
B
F
L
J
F
5. Insert a foot
D
shown. Secure each foot with one 8-16 X 75 mm screw
and four 8-16 X 18 mm screws
E
E
securely but do not overtighten. DO NOT USE POWER
TOOLS.
IMPORTANT: Each foot MUST sit completely flat in the
the stabilizer tubes is not installed correctly or is not fully
reinstall until the foot fits over it correctly.
B
H
B G
I
J
Triangles
K
K
3
Assembling the ExerSaucer
C B
into the bottom of each pylon , as
D
E
. Tighten all 10 screws
C
D
E E
F
6. Place seat ring upside down and
locate the wheel holders G .
H
Snap four seat wheels into wheel
holders, as shown.
7. Turn seat ring F right side up.
Align the two triangles on the
back of the seat ring with the two
triangles on the label on the seat
pad I .
Snap the plastic tabs J on the pad
over the pegs K on the seat ring.
Continue this process until all tabs
are attached to all pegs.