COFAN 0900 0913 Manual De Instrucciones página 23

- Nails are inaccurately fed into
the Blade Guide.
- Incorrect nails are loaded.
Le clou - guide est
- Worn driver blade.
tordu.
- The wood is too hard.
- The wood is too hard.
- Air pressure too low.
The driven nails do
- Worn or broken driver blade.
not fully penetrate
the work piece
(heads protrude).
- Incorrect driving depth ad-
justment.
- Defective piston ring (worn or
broken).
- Defective inner surface of
cylinder (worn o rough).
- Nails are inaccurately fed into
the blade guide.
- Incorrect nails are loaded.
- Worn tip pf the driver blade.
Nails clog within
the ejecting gate.
- Worn guide groove of the blade
guide.
- Work piece material is too hard.
General Troubleshooting Guide
- Refer to item above.
- Check if the driver blade is
extremely worn or not.
- Check if the nails bend on
softer wood or not.
- Carry out idle driving and check
if the driver blade protrudes from
the blade guide nose.
- Check if the tip of the driver
blade is excessively worn or not.
- Disassemble the output unit
and check the inside and outside
surface of the piston ring and
cylinder.
- Refer to first item.
- Carry out idle driving and check
if blade is worn or not.
- Check the wear of the blade
guide.
ENGLISH
- Refer to item above.
- Replace the driver blade.
- Stop using the tool.
- - Stop using the tool.
- - Adjust the air pressure.
- If the driver blade does not
protrude from the blade guide
replace.
- Adjust the guide place to the
appropriate position.
- Replace the defective parts.
- Refer to first item.
- Use designated nails.
- Replace.
- Replace.
- - Stop using the tool
21