Installation & Assembly - HOMEDEPOT WL0940DMD40 Manual De Instrucciones

INSTALLATION & ASSEMBLY:
1. Turn off the power at the circuit breaker box.
2. Remove the fixture from the packaging.
3. Remove the lens (A) from the fixture (C), then squeeze the
cover (B) and remove it from the fixture (C) (Fig. 1).
M M
OUNTING ETHOD
1. Center the fixture over the outlet box in the desired location
and mark the mounting holes with a pencil.
2. Drill the appropriately sized mounting holes in at each
marked location. Anchors or other hardware may be needed
depending on the surface type.
3. Insert the black supply wire and the white supply wire
into the empty quick connector (D) (Fig. 2).
4. Pull the quick connector (E) through the central knockout
hole (F). (Fig. 3).
5. Connect the fixture quick connector (E) to the power
supply quick connector (D). Connect the supply ground
wire to the fixture ground wire using a wire nut.
6. Connect the purple and grey wires from the dimmer to
corresponding wires of the wall 0-10V dimmer (Fig. 4).
7. Restore power at the circuit breaker box
M M
OUNTING ETHOD
1. Place the fixture in the desired location and mark the
mounting holes with a pencil.
2. Drill the appropriately sized mounting holes in at each
marked location. Anchors or other hardware may be needed
depending on the surface type.
3. Use the knockout on the end cap of the fixture to bring in the
supply wires.
4. Insert the black supply wire and the white supply wire
into the empty quick connector (D) (Fig. 2).
5. Pull the quick connector (E) through the end cap
knockout hole.
6. Connect the fixture quick connector (E) to the power
supply quick connector (D). Connect the supply ground
wire to the fixture ground wire using a wire nut.
7. Connect the purple and grey wires from the dimmer to
corresponding wires of the wall 0-10V dimmer (Fig. 4).
8. Restore power at the circuit breaker box.
1
2
.
Fig. 1
Fig. 2
Fig. 3
FIXTURE WIRES DIMMER WIRES
PURPLE PURPLE
GREY GREY
Fig. 4