Cleaning And Maintenance - Black and Decker Dustbuster V4805 Manual De Instrucciones

ENGLISH
2. Release button
3. Dust bowl
4. Charging base
5. Filter cleaning wheel (CV9605/CV1205)
6. Charging indicator
Fig. A
7. Crevice tool
8. Brush tool
Installation
Fitting the charging base to the wall
(fig. B)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point for
the appliance.
Assembly
Fitting the accessories (fig. A & C)
These models are supplied with the
following accessories:
- a crevice tool (7) for confined spaces
- a brush tool (8) for furniture and stairs
To fit an accessory, proceed as follows:
Take the accessories from the
appliance.
Insert the appropriate accessory into
the front of the appliance.
Use
Before first use, the battery must be
charged for at least 16 hours.
Place the appliance on the charging
base whenever it is not in use.
Charging the battery (fig. B)
Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch in the
on position.
Place the appliance on the charging
base as shown.
Plug in the charger. Switch on at the
mains.
The charging indicator (6) will be lit.
Leave the appliance to charge for at
least 16 hours.
6
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charging indicator will be lit as long
as the appliance is connected to the
plugged-in charger.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
Switching on and off (fig. D)
To switch the appliance on, slide the
on/off switch (1) forward.
To switch the appliance off, slide the
on/off switch back.
CV9605/CV1205 - Optimising the
suction force (fig. E)
In order to keep the suction force
optimised, the filter must be cleared
regularly during use.
Rotate the wheel (5) a few turns to
shake out dust clogging the filter (9).

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. F - I)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and
remove the dust bowl (3) (fig. F).
Empty the dust bowl (fig. G).
Remove the filters (9 & 10) by
twisting them clockwise (fig. H).
Brush any loose dust off the filters.
Wash the filters in warm, soapy
water (fig. I). The bowl can also be
washed if necessary. Do not immerse
the appliance in water (fig. J).
Make sure the dust bowl and filters
are dry.
Refit the filters (9 & 10) onto the
appliance, twisting them
counterclockwise until they lock into
place.
Refit the dust bowl onto the
appliance. Make sure the dust bowl
clicks into place.