Telstar TVP301210MD Manual De Instrucciones página 7

3 IN 1(MULTIFUNCTIONAL)FAN
TVP301210MD
ASSEMBLE OF FAN
1. Unscrew the spinner (2) and the plastic nut (4) counter clockwise from the front of the motor housing (8)
then remove both of them.
2. Set the rear grill (5) in the proper position with handle up.
3. Screw the plastic nut (4) firmly onto the projecting thread on the motor housing (8), by rotating clockwise
and tighten firmly.
4. Install the fan blade (3) onto the shaft with the cutout fitted on the retaining pin. Screw the spinner (2) onto
the motor shaft counter clockwise.
5. Press the 6 rim locks of the front grill (1) onto slots of the rear grill (5) until the front grill (1) is properly fitted.
STAND FAN ASSEMBLY
1. Take the chassis (14) and column parts (11+12+13) from the packing box. Insert the inside-pole (11) into the
outside-pole (13), and screw the locknut (12) to tighten columns. (See Fig.1)
2. Insert the pole into the square slot of the chassis (14), and press out (See Fig.2)
3. Overturn the chassis (14), tighten the 4 screws into the screw holes of the chassis bottom. (See Fig.3)
4. Loosen the locknut (12) to adjust the inside-pole (11) into an appropriate position, and tighten the locknut
(12). (See Fig.4)
5. Loosen the screws of the motor housing (8), put the motor housing onto the inside-pole (11), and tighten
the screw. (See Fig.5)
Fig. Fig.
Fig.3
Screw
Fig. Fig.
e
e
ig i g w cre
7