Telstar TVP301210MD Manual De Instrucciones página 8

TABLE FAN ASSEMBLY
1.
Put the Link-to-Chassis (17) into the chassis (14), and press out. (See Fig.6)
2.
Overturn the chassis (14), tighten the 4 screws into the screw holes of the chassis bottom. (See Fig.7) Notes:
If you have fixed the pole into the chassis, you have to take down pole from the chassis first.
3.
Loosen the screws of the motor housing (8), put the motor housing (8) onto the inside-pole (11), and tighten
the screw. (See Fig.8)
Fig.6
WALL FAN ASSEMBLY
Fan should be installed onto the wall or post, which should be perpendicular to the ground.
Notes:
In order to avoid any fell off, you must firmly drive the screws of the wall-fixing
(16) into the wall.
1.
Drive two screws into the wall firmly, with the horizontal distance of 72mm between the two screws, and
12mm from the screw head to the wall. Then fix the wall-fixing (16) onto the wall with screws, and screw them
firmly. (See Fig.9)
2.
Mount the wall fan on the wall-fixing (16). (See Fig.10)
Fig.9
Fig.7
ceiling
8
3 IN 1(MULTIFUNCTIONAL)FAN
Fig.8
Screw
Tighting screw
Fig.10
Tighting screw
TVP301210MD
Hole