Marmitek PROGUARD800 Serie Modo De Empleo página 6

9. Press the Transmitter Delete button on the siren in order to clear the siren's
register; the siren sounds an acknowledge tone.
10. On the control panel, perform the External Siren Test twice in order to register
the control panel's transmitter to the OS826's receiver.
To perform an External Siren Test:
• From the Service menu, select WL. Siren Test [7
each transmission. The siren sounds an acknowledge tone when each
transmission is received. When you push 9 for a third time, you will hear a double
acknowledge tone.
Note: During the registration procedure, make certain that no other wireless
devices are transmitting so as not to interfere with registration. In the event
that the wrong transmitter is registered to the siren's receiver, you can delete
the transmitter by pressing the Transmitter Delete button while the Mode
jumper (JP1) is set to Registration mode and repeat step 10.
11. Register the OS826's transmitter to the control panel's receiver.
12. Set the control panel to Registration mode as follows:
• From the Programming menu, select Devices, Siren, 1.WL. SIREN
REG. [915]. On the display you will see TRANSMIT 1
• Set the siren to Transmission mode by placing the Mode jumper (JP1)
as shown in Figure 4; the siren transmits a signal every few seconds.
• When Save? appears on the control panel's LCD display, press 9 on
the control panel's keypad.
13. Remove the Mode jumper (JP1) on the siren and place it over one pin for
storage and disconnect the power supply.
14. Configure the Arming Tones jumper (JP2) as required. If the jumper is
removed, the siren sounds tones and flashes the strobe on arm/disarm. If the
jumper is installed, the siren flashes the strobe on arm/disarm but no tones
are sounded.
15. Choose a suitable mounting position for the siren. The siren should be
mounted on a flat surface in a highly visible position for maximum deterrence
against potential intruders.
16. Before permanently mounting the siren, test the reception from the exact
mounting position. If necessary, relocate the siren to a better position.
17. To mount the OS826, place the back cover in position against the wall and
mark the upper and lower mounting holes. Install wall anchors in the
appropriate positions.
5
REGISTRATION MODE h
TRANSMISSION MODE h
Figure 4: Mode Jumper Configuration
]; Press 9 for
© MARMITEK