GE RAKUVC1 Instrucciones De Instalación página 3

Installation Instructions
STEP 3:
Remove Control Panel from Zoneline Unit
1. If applicable, remove and discard the existing junction box and screws.
2. Remove and retain the three 5/16" screws securing the control panel.
3. Unplug the power connection to the control panel and personality plugs.
4. Remove the control panel from the Zoneline unit and set aside.
Remove and retain 3 screws
Junction Box
Remove and discard existing junction box, if present.
STEP 4:
Remove Vent Trim from Zoneline Unit
wire connector
1. Remove the 7 screws securing the vent trim using 5/16" driver. Retain screws and vent trim to reinstall later.
disconnected from the connector on the wiring harness.
3