Publicidad
Problem
EN
The iron is plugged
in, but the soleplate
is cold.
The iron does not
produce any
steam.
The iron does not
produce a
steam boost.
Water droplets drip
onto the fabric during
ironing.
14
Possible cause
There is a connection
problem.
The temperature dial is
set to MIN.
There is not enough
water in the water tank.
The steam control is set
to position (see
The iron is not hot
enough and/or the drip-
stop function has been
activated.
You have used the steam
boost function too often
within a very short period.
The iron is not hot
enough.
There is not enough
water in the water tank.
You have not closed the
cap of the filling opening
properly.
You have put an additive
in the water tank.
The set temperature
is too low for steam
ironing.
You have used the
steam boostfunction at
a temperature setting
below •••.
Solution
Check the mains cord, the plug and
the wall socket.
Set the temperature dial to the
required position.
Fill the water tank (see
Move the steam control to a
).
position somewhere between the
black zone (see
Set an ironing temperature that is
suitable for steam ironing (•• to
MAX). Put the iron on its heel and
wait until the temperature light has
gone out before you start ironing.
Continue ironing in horizontal
position and wait a while before you
use the steam boost function again.
Set an ironing temperature at which
the steam boost function can be used
( ••• to MAX). Put the iron on its
heel and wait until the temperature
light has gone out before you use the
steam boost function.
Fill the water tank (see
Press the cap until you hear a click.
Rinse the water tank and do not
put any additive in the water tank.
Set a temperature of •• or higher.
Set the temperature dial to a
setting between ••• and MAX.
).
).
).
Publicidad
