Metra XSVI-1788-NAV Guia De Inicio Rapido

INSTXSVI-1788-NAV
• Connect the Blue wire to the antenna turn on wire of the aftermarket radio.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
The following wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio (if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio (if applicable).
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation
radio (if applicable).
• Cycle the key by turning the ignition on for 30 seconds, then "off" and "on" again to
test the radio.
ASWC-1 (if installing)
After the XSVI is initialized, plug in the ASWC-1 into the 12 pin harness of the
XSVI-1788-NAV and refer to the ASWC-1 instructions.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
1-800-221-0932
REV. 9/8/14 © COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians
metraonline.com
INSTXSVI-1788-NAV
XSVI-1788-NAV
Dodge/Mercedes/Freightliner accessory and
NAV output CAN harness 2008-up
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, and V.S.S.)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• USB updatable
APPLICATIONS
DODGE
Sprinter (sound 20/50 radio) 2008-2009
MERCEDES
Sprinter (sound 20/50 radio) 2010-up
Caution: Metra recommends disconnecting the negative battery terminal before beginning
any installation. All accessories, switches, and especially air bag indicator lights must be
plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
Connections to be made
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Red wire to the ignition wire of the aftermarket radio.
• Connect the Orange wire to the illumination wire of the aftermarket radio. If the
aftermarket radio has no illumination wire, tape off the Orange wire.
1-800-221-0932
REV. 9/8/14 © COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION
FEATURES
FREIGHTLINER
Sprinter (sound 20/50 radio)
metraonline.com
2008-up