Metra XSVI-1788-NAV Manual De Instrucciones

XSVI-1788-NAV
Dodge/Mercedes Sprinter 2007-up
XSVI-1788-NAV
Dodge/Mercedes (with sound 20 sound system)
accessory and NAV output CAN Interface
• Provides accessory (12 volt 10 amp)
• Retains R.A.P. (retained accessory power)
• Used in non-amplified systems or when replacing amplified systems
• Provides NAV outputs (parking brake, reverse, V.S.S.)
• Prewired ASWC harness included (ASWC sold separately)
• High level speaker input
• USB updatable
APPLICATIONS
DODGE
Sprinter
MERCEDES
Sprinter
1-800-221-0932
REV. 7/25/13 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
2007-up
2007-up
metraonline.com
XSVI-1788-NAV
Wiring the XSVI-1788-NAV
From the 16-way
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Red wire to the ignition wire of the aftermarket radio.
• Connect the Orange/White wire to the illumination wire of the aftermarket radio.
If the aftermarket radio has no illumination wire, tape off the Orange wire.
• Connect the Blue wire to the antenna turn on wire of the aftermarket radio.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio.
Initialize the XSVI interface
With all connections made and harnesses connected to the vehicle, turn the ignition key
to the ON position for 30 seconds, then turn the key OFF, then ON again to test the radio.
ASWC (if installing)
After the XSVI is initialized, plug in the ASWC into the 12 pin harness of the
XSVI-1788-NAV and refer to the ASWC instructions.
1-800-221-0932
REV. 7/25/13 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
metraonline.com