Kohler K-704410 Manual Del Usuario página 7

Ocultar thumbs Ver también para K-704410:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Wider edge towards
outside of shower.
Wall jamb must sit flat
against wall and fully
engage bottom track.
Short Legs
3. Mark the Wall Jamb Locations
Position a wall jamb against the wall directly over the bottom track. The wall jamb should sit flat
against the wall.
Slide the wall jamb down over the bottom track until the wall jamb and bottom track are fully
engaged.
NOTE: The wall jamb must sit flat on the bottom ledge. If your ledge has a curve in the corners at the side
wall, it may be necessary to shape the bottom end of the wall jamb with a file.
Use a level to plumb the wall jamb vertically.
Using the pre-drilled screw holes as a guide, mark the hole locations on the wall.
Repeat the procedures with the second wall jamb.
Remove the bottom track and wall jambs.
NOTE: When installing on ceramic tile, use a center punch to nick the surface of the glaze. Tap the center
punch lightly with a hammer to avoid cracking the tile.
Lightly center punch the hole locations.
Drill a 5/16" hole at each mark. Use a tile or masonry bit for ceramic tile.
Press and hold the legs of each anchor (provided) together and insert the anchor legs into the
pre-drilled mounting holes.
Repeat for all the anchors.
Thoroughly clean the shower floor ledge and wall.
Kohler Co.
Wall Jamb
Bottom Track
Wall Jamb
Mark holes.
Level
Wall
Jamb
7
Press and hold legs together.
Drill holes.
Insert anchors.
1015439-2-D

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-704412K-704414

Tabla de contenido