Grounding Instructions - Hunter The Millenniom Guia Del Propietario

groUnding inStrUctionS

This appliance is for household use
only and may be plugged into any
120-volt AC electrical outlet (ordi-
nary household current). DO NOT
use any other type of outlet.
Warning
This unit is suitable for grounded
receptacle use only.
The cord has a grounded plug as
shown in Figure 1. An adapter, as
shown in Figure 2, is available for
connecting three-blade grounding-
type plugs to two-slot receptacles.
The green grounding lug extending
from the adapter must be con-
nected to a permanent ground such
as a property grounded outlet box.
The adapter should not be used if
a three-slot grounded receptacle is
available.
Grounded
Plug
Grounding Pin
Grounded Outlet
Box Cover
FIGurE 1
44801-01
LINE CORD SAFETY TIPS
1. NEVER pull or yank on the
cord or the appliance.
2. To insert plug, grasp it firmly
and guide it into the outlet.
3. To disconnect the appliance,
grasp the plug and remove it
from the outlet.
4. Before each use, inspect the
line cord for cuts and/or abra-
sion marks. If any are found,
the appliance should be
serviced and the line cord re-
placed. Please return it to our
Service Department or to an
authorized service representa-
tive.
5. NEVER wrap the cord tightly
around the appliance, as this
could place undue stress on
the cord where it enters the
appliance and could cause it to
fray and break.
6. DO NOT operate appliance if
the line cord shows any dam-
age, if the appliance works
intermittently or stops working
entirely.
Adapter
Metal
Screw
Grounding Grounded Outlet
Box Cover
Means
FIGurE 2
[4]
02/07/2008
operation
This appliance is for household
use only.
1. Place the fan on a dry, safe,
flat surface where it cannot fall
or be pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
DO NOT use any other type
of outlet. Make sure that the
rated voltage of the fan is the
same as the power source be-
fore plugging it into the power
source.
3. Turn the fan "ON" or "OFF" by
turning the Power/Speed Con-
trol knob. The power should
always be OFF before unplug-
Decorative Pieces
(Only on 9103X &
9703x models)
Power/Speed
Control Knob
FIGurE 3
44801-01
ging the fan.
4. To select the speed, turn the
Power/Speed Control knob
from OFF to the desired speed
setting: O (off), I (low), II (me-
dium), III (High).
5. To control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten
the screw.
6. To make the fan oscillate, push
the oscillation knob down. To
stop oscillating, pull the oscil-
lation knob up. The oscillation
knob is located on the top of
the fan housing, near the han-
dle.
Handle
Oscillation Knob
Motor Housing
Up/Down Adjustment Screw
Base
[5]
02/07/2008