Grammer KINGMAN Manual De Instrucciones página 21

During the removal and installation of the driver's seat, the corresponding instructions by
• • • •
the specific vehicle manufacturer must be strictly observed!
Do not hold onto the covers for lifting the driver's seats. If you do so anyway, there is an
• • • •
increased risk of injury due to loosening or breaking covers.
Before you remove the driver's seat, disconnect all plug-in connections between the seat
• • • •
and the vehicle supply network and disconnect the battery supply. When you replace the
plug-in connectors, make sure they are tight (dust, water).
If the seat is equipped with seatbelts, check them for correct function.
• • • •
Seatbelts must be fastened before driving.
• • • •
The seatbelts must be replaced after an accident.
Where seatbelts are fitted to the driver's seat, the seat and seat mounting must be
checked additionally by specialist personnel after an accident has occurred.
Retro-fitting of driver's seats with integrated seatbelts is only admissible after consulting the
• • • •
vehicle manufacturer and with proper fitting by authorized workshops.
Fasteners must be checked regularly for tight seat. If the seat wobbles, there may be
• • • •
loose bolts or other faults.
If you find that the seat does not function correctly (for example a defective suspension of
• • • •
the driver's seat; improper curvature of the lumbar support, etc.) or is damaged (e.g.
damaged bellows etc.) contact a specialist workshop immediately to arrange for repairs
to be carried out.
If you fail to do so, your health may be affected and the risk of accident increased.
Do not indent the bellows while there is load on the driver's seat.
• • • •
– RISK OF CRUSHING –
Make sure that the interior of the driver's seat remains free of foreign particles or
• • • •
liquids.
The driver's seat is not watertight and must be protected against splashes of water!
• • • •
Any conversion or refitting work on a GRAMMER AG driver's seat must be performed
• • • •
exclusively in authorized workshops by trained or suitably qualified personnel and in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
Improper installation and assembly bear the risk of bodily injury or property damage
• • • •
and the proper function of the driver's seat or mounted parts can no longer be guaranteed.
To ensure proper function of the driver's seat and to prevent damages of the pneumatic
• • • •
spring, adjust the loaded driver's seat to the highest height position (see "Height
adjustment") after it has been fitted into the vehicle. Please make sure that the normal
working pressure is available in the vehicle's air supply system. In case of non-observance,
the guarantee will expire.
GB
Safety instructions
21