ideTronic PSLQ10 Manual De Instrucciones página 10

UK
Central installation
Run the sensor wires through the wire tube
of the vehicle. To observe the order of the
connection of the sensors (A left side, B left
central, C right central, D right side) to the
blue connectors of the central.
Plug the red-black wire to the reversing light
of the vehicle.
Fit the beeper with the included self-adhesi-
ve in a place where it can be listened from
the inside of the vehicle.
Plug the white connector from the wire loom
to the red connector of the central.
Finally fi t the central with the included
self-adhesive.
Verifi cation of Performance.
Once you put the reverse you must listen a BEEP of activation. Run slowly in order to verify the correct
performance.
If it seems not working properly, verify the follow:
The sensors are in the correct order.
All the connections are well done.
Check the distances of the installation.
All sensors are on the right way, the arrow of the rear side has to be looking up (↑UP).
Atention
In some situations the equipment can not indicate with precision for example:
Under Obstacle
Note: you must clean the surface before to fi t the self-adhesive.
curved Obstacle inclined surfaces