Sensor Installation - ideTronic PSLQ10 Manual De Instrucciones

Parking Assist ideTronic PSLQ10
This system is a parking assistance, that doesn't
excuse you to take care when maneuvering the
vehicle, Keeping in view of the movement area.
If your vehicle is equipped with monitoring of the
reversing light consumption fi rst test to see that no
error prompted by the use of equipment.
Kit formed by
1 Central
4 Sensors
1 Beeper
1 Connecting wire and beeper.
4 Self-adhesives Supports
4 fl anges
1 Hole saw of 20mm

Sensor Installation

X L L L
X = 0.20m ~ 0.30m
The installation has to be done on smooth surface of the bumper.
To verify that the sensor is inserted in its totality and that doesn't exist space between the sensor and the
bumper. In order to improve the fi t of the sensor we recommended applying a silicone ring in the back side
of the sensor with the bumper.
To check that the sensor is on the right way. The arrow of the rear side has to be looking up (↑UP).
In order to fi t the wires in the internal part of the bumper use the self-adhesives and the fl anges included.
Note: you must clean the surface before to fi t the self-adhesive.
Necessary Tools not included
X
h = 0.50m ~ 0.70m
The external surface has to be
perpendicular with the fl oor
UK