Tabla de contenido
Publicidad
Contents
Approval Conditions
This Deckvest is approved to ISO 12402-3 (150N) or ISO 12402-2 (275N). It is important to
get into the habit of wearing your Deckvest. It is comfortable, safe and a pleasure to wear.
Minimum Buoyancy - 150N or 275N.
A lifejacket only works correctly if it is fitted and secured correctly.
Inflatable lifejackets only become buoyant when inflated: they contain no inherently buoyant
materials.
As user, it is your personal responsibility to understand the operation and maintenance
requirements of your inflatable lifejacket and be familiar with its limitations.
Re-arming your Deckvest Duro
Remove cylinder and old firing cap by unscrewing anti clockwise. Check firing mechanism
moves freely and is free from any contamination. Then replace first with a new cap and
then with the new cylinder, ensuring a secure fit. Check/Replace the manual pull green
indicator clip if required.
Inflating your Deckvest Duro
It is recommended that the following inflation procedures are followed:
1. MANUAL INFLATION
To manually inflate the lifejacket, sharply pull the rubber handle downwards.
gas cylinder should inflate the bladder within seconds.
2
2. ORAL INFLATION
To inflate the lifejacket by mouth, locate the oral inflation tube by opening the zip at
the yellow breakout point on the front panel of the lifejacket. Then after removing
the end cap, blow into the tube until the lifejacket is fully inflated.
3. AUTOMATIC INFLATION
Inflation should occur automatically within seconds of the inflator being submerged.
Page no:
3-4
5
6
6
6-7
7
8
9-41
42
2
6
Publicidad
Tabla de contenido
