Checking The Water Dispenser Line; Installing The Water Dispenser Line; Connecting To The Water Supply Line - Samsung RS26DDA Serie Manual De Instrucciones

setting up your side-by-side refrigerator

CHECKING THE WATER DISPENSER LINE

A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote
better health, the Samsung water lter removes unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to
do that.
In order for the ice maker to operate properly, a water pressure of138~862 Kpa is required.
Under normal conditions, a 170 cc (5.75 oz.) paper cup can be lled in 10 seconds.
If the Refrigerator is installed in an area with low water pressure (below 138Kpa), you can install a
booster pump to compensate for the low pressure.
Make sure the water storage tank inside the Refrigerator is properly lled. To do this, press the water
dispenser lever until the water runs from the water outlet.
Water line installation kits are include with unit. You can nd it in freezer drawer.

INSTALLING THE WATER DISPENSER LINE

Parts for water line Installation

Connecting to the water supply line

1. First, shut o the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in the installation kit.
Close Main
Water pipe
4. After connecting the water supply to the water lter, turn your main water supply back on and
dispense about 3L to clear and prime the water lter.
The water line must be connected to the cold water pipe. If it is connected to the hot water
pipe, it may cause the puri er to malfunction.
CAUTION
18_setting up
1 Water line xer 2 Pipe connector
and screws
3 Water line
Close Main NO GAP
Water pipe