Transport And Storage - FITFIU FITNESS RA-200 Manual Usuario

MAINTENANCE
• Make sure you have turned off the appliance and disconnected the plug before servicing.
• Do not clean with abrasives or solvents to avoid damage to finishes.
• Be careful not to allow excessive moisture to enter the display panel as it may damage the display and create an
electrical hazard.
• Keep the equipment, especially the display console, out of direct sunlight to avoid damage.
•
To clean around the plug and control panel use a soft, dry cloth, never use wet cloths.
• Do not insert the cleaner into the appliance to avoid hazards.
• Do not use the air oar in wet or dusty environments as this can lead to leakage or mechanical failure. Use this
product on a flat surface.
TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem
The display does not show
anything
The machine wobbles when in use.
Rowing machine makes a
squeaking noise when in use

TRANSPORT AND STORAGE

To move the machine, raise the rear stabiliser until the transport wheels of the front
stabiliser touch the ground. With the wheels on the ground, easily transport the
machine to the desired location.
To save space, fold down the slide rail (2). Pull the pin (33) to fold the rail (2) at a vertical
angle, then insert it to lock the rail (2) in place.
ATTENTION: Be careful when folding the rail (2) vertically, its
head may touch the stabiliser of the rear support.
Store the equipment in a clean and dry indoor environment. Never leave or use the unit outdoors. Make sure that the main
power switch is turned OFF ("O") and the power cord is disconnected from the mains.
Remove the console from the computer and check that the cable coming out
of the computer console is properly connected to the cable coming out of the
handlebar post
Check that the batteries are correctly inserted and that the battery springs
are in good contact with the batteries
The batteries in the computer console may be dead. Replace the batteries
with new ones
Turn the knob on the rear stabiliser end as necessary to level the rowing
machine
Bolts may be loose on the rowing machine. Inspect all bolts and tighten any
loose bolts
36
Solution
2
1
33