Facom ACCUPOWER DX.B1100 Guía De Instrucciones página 6

C - DESCRIPTION
Cable storage groove
Clip connectors
Voltage rating
D - OPERATION
Before using your Accupower for the first time, be sure to charge it up for at least 12 hours.
1- Ensure that the battery needing a boost is rated 12V (Fig. 1).
2- Important: Always keep the unit charged :
i.e. at least 1 green LED illuminated (Fig. 2).
3- Place gear selector in neutral (Fig. 3).
4- Apply parking break (Fig. 4).
5- Connect red clip to vehicle battery positive (+) (Fig. 5).
6 - Connect black clip to engine ground or vehicle battery negative (-) (Fig. 6).
7- Run starter motor (no more than 10 seconds).
Allow 2 minutes between each attempt to start lasting 10 seconds (Fig. 7).
8- When engine has started (Fig. 8)
- first disconnect the black clip.
9- Then remove the red clip (Fig. 9).
10- Remember to put the unit back on charge, ready for the next time (Fig 10).
Always keep your Accupower charged. Operation while insufficiently charged
may irreversibly damage the high-power battery.
OTHER USES.
Units DX.B1100 and DX.B1600
system data when changing a battery, or for powering 12V
items e.g. portable refrigerator, inspection lamp and other lighting, telephone, radio and power tools.
E - CONSUMABLES
Désignation
Red clip
Black clip
Cigarette lighter adaptor
Charger 240 v /14.9v
Battery
Red lead
Black lead
Handle
can function as an emergency power supply, for instance to preserve on-board
DX.B1100 DX.B1600
DX.BPR DX.BPR
DX.BPN DX.BPN
DX.BC12 DX.BC12
DX.BC240 DX.BC240
DX.B19AH DX.B16AH
DX.BCR DX.BCR
DX.BCN DX.BCN
Charge status diodes
Charge test button
12V charge or other output
Insulatedshock-resistant cover