Airspa Troubleshooting; Reclining Tension Adjustment Instructions - LAZBOY Air Spa Instrucciones De Operación

AirSpa ® 10-Motor Massage & Heat Recliner
Troubleshooting:
WARNING
– To reduce the risk of injur y:
• Do not attempt to disassemble or service the pump or motor. No serviceable
parts are inside. Contact your La-Z-Boy
Troubleshooting for AirSpa ® 10-Motor Massage & Heat Recliners
There are no user maintenance or repair requirements. If the massage or heat
functions do not work:
1. Make sure the Power Transformer is plugged into an electrical outlet.
2. Make sure the electrical outlet is working. For example, make sure there are
no blown fuses or tripped circuit breakers.
3. Make sure the connectors are secure; refer to the Assembly Instructions.
4. Make sure the electrical cords are not crimped or pinched. Make sure the
electrical cord or plug is not damaged.
If the massage or heat system still does not operate properly, contact your
dealer for instructions on returning the unit for examination and repair. Except
for replacement of the Power Transformer, never attempt to make any repairs
or adjustments yourself.
Power Transformer Replacement
If the Power Transformer must be replaced:
1. Unplug the Power Transformer from the electrical outlet.
2. Locate the Power Transformer connection behind the unit; refer to the
Assembly Instructions. Gently pull the connectors apart to disengage.
3. Push the replacement Power Transformer connector and the body connector
tightly together; refer to the Assembly Instructions.
12
® dealer for service information.
Reclining Tension Adjustment
Instructions:
WARNING
– To reduce the risk of injur y:
• This unit is equipped with a tension adjustment feature for the reclining
mechanism that is preset at the factor y. The tension setting can be
changed for your personal preference. To avoid tip over and insure
stability, do not operate the unit with the tension adjustment wing nuts
completely loosened.
NOTICE:
To reduce the risk of product damage:
• Make sure the legrest is closed before tilting forward and adjusting
the tension.
• Do not completely tighten the wing nuts. The tension springs should not be
completely compressed after making adjustments. If this occurs, the wing
nuts must be loosened a minimum of
tension assembly.
• Do not completely loosen the wing nuts. The spring should not slide on
the bolt after making adjustments. If the spring slides on the bolt, tighten
the wing nut clockwise a minimum of
slides on the bolt.
• Adjust bot h wing nuts equally.

Reclining Tension Adjustment Instructions:

You can adjust the tension of the reclining mechanism to respond to your
individual size.
1. Gently roll the reclining chair forward to rest on its arms and top of the back.
Locate the wing nuts, one on each side, toward the back of the recliner under
the reclining seat (F 1; only one side shown).
IGURE
2. Adjust the tension by turning the wing nuts in
desired setting is reached.
• A taller or heavier person may choose to increase the reclining tension
by tightening the wing nuts clockwise.
• A smaller person may choose to decrease the reclining tension by
loosening the wing nuts counterclockwise.
3. Return the reclining chair to the upright position and test the new setting.
Make additional adjustments if needed, repeating these steps.
F 1
IGURE
1 ⁄ -turn to avoid damage to the spring
2
1 ⁄ -turn after the spring no longer
2
1 ⁄ -turn increments until the
4
Wing Nut Tension Spring
13