Lenco CR-335 Manual Del Usuario página 4

ventilation openings. The ventilation should not be impeded by
covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc. Also, it should not be placed in a built-in
installation, such as a bookcase or cabinet, which may impede the flow
of air through the ventilation openings.
3. Heat & Flame
The unit should be situated away from heat sources such as radiators,
heat registers, stoves or other appliances (including amplifiers) that
produce heat.
No naked flame sources, such as lighted candles, should be placed on
the apparatus.
4. Power Source
The unit should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
Where the power cord is used as the disconnect device, the
disconnect device shall remain readily operable.
5. Power Cord Protection
Power supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them. It is
always best to have a clear area from where the cord exits the unit to
where it is plugged into an AC outlet.
6. Cleaning
The unit should be cleaned only as recommended. See the section
"Care and Maintenance" of this manual for cleaning instructions.
7. Object and Liquid Entry
Care should be taken so that objects do not fall and liquids are not
spilled into any openings or vents located on the product. It shall not be
exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
8. Attachments
Do not use attachments not recommended by the product
manufacturer.
9. Lightning and Power Surge Protection
Unplug the unit from the wall outlet and disconnect the periods of time.
This will prevent damage to the product due to lightning and power-line
surges.
10.Overloading
Do not overload wall outlets, extension cords, or integral convenience
receptacles as this can result in a risk of fire of electric shock.
11. Damage Requiring Service
This unit should be serviced by qualified service personnel when:
A. The power supply cord or plug has been damaged.
4