Radio Tuner Operation - Lenco CR-335 Manual Del Usuario

12. WAVE Sensor
13. LED Display
14. PM LED indicator ----- In 12 hours display format mode: LED on for
pm, LED off for am
15. Radio mode LED Indicator
16. ALM 1 switch ---- Select alarm source or disable alarm 1
17. ALM 2 switch ---- Select alarm source or disable alarm 2
18. ALARM 1 LED indicator
19. ALARM 2 LED indicator
20. AUX (auxiliary) mode LED indicator
21. VOLUME wheel ----- Adjust volume level
22. TUNING wheel ---- Tuning FM radio frequency
23. FM frequency dial scale
24. Clock backup battery compartment ---- Located at bottom of the unit
25. Speaker
26. AC Power Cord
27. FM Antenna wire
28. RESET button ---- For resetting the unit
29. AUX-IN jack ---- Auxiliary audio signal input
FM Antenna
Fully extend the FM antenna wire for the best FM radio reception.
Radio Tuning
1. Press the POWER button to turn on the unit, where the Radio mode
LED indicator light on.
Note: When a 3.5mm auxiliary plug is inserted in the AUX-IN jack,
the unit will be at auxiliary mode and the AUX LED indicator lights
on. If it is the case, unplug the auxiliary plug at rear of the unit and
the Radio mode LED indicator lights on again.
2. Turn the TUNING wheel tuning to a desired radio station.
3. Turn the VOLUME wheel to adjust the volume to a desired level.

Radio Tuner Operation

9