Operating The Compressor Nebulizer - Roscoe Medical NEB-RITE4 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14. When treatment is finished, shut off the unit and unplug it from the electrical
outlet.
• The compressor motor has a thermal protector, which will shut off the unit before
it becomes overheated. When the thermal protector shuts the unit off, please:
a.
Switch off the unit.
b.
Unplug the unit from the electrical outlet.
c.
Wait 40 minutes for the motor to cool down before starting another treatment.
d.
Make sure the air openings are not obstructed and air filter is clean.
• Never operate if this unit has a damaged cord or plug, has been dropped
in any way, immersed into water or if it does not work properly. Return it to a
service center for repair.
• If any abnormality occurs, discontinue use immediately until the unit has been
examined and repaired.
• Always unplug the product immediately after use.
• Never allow the power supply cord to be pulled, jerked, strained, twisted or
severely bent, especially at the plug connections. Damage will occur at the high
flex point of entry into the appliance, causing it to rupture and short. Handle the
cord carefully for longer life.
• Never block the air openings of the main unit or place it where the air openings
may be obstructed.

OPERATING THE COMPRESSOR NEBULIZER

1. Take the power cord and plug into an electrical outlet. (Figure 9)
2. Check for moisture leakage near the nebulizer connections.
WARNING!
11

Publicidad

Tabla de contenido
loading

Tabla de contenido